Posted on June 14, 2010.
Hat Needle Case and Thimble Holder Posh You will need ...
Some pieces of felt, embroidery thread, and a sense of the pattern pieces. Who can be printed freely on the site SantasPostbag.
Cut out the pattern pieces from the sheet to print. Place the pieces of the pattern onto the felt and pin in place. Put the pieces of felt on the periphery and close to the other side, because it saves fabric. Cut out the pattern pieces, it is not necessary to leave a seam allowance, cut right to the sales pitch.
Each piece of the boss says this about what part of the hat, it is and how you need to cut.
Use embroidery thread to sew together your hat. Embroidery thread is generally composed of six parts. Split the thread to use only three components to sew with.
Get the top hat and prepare two-piece sewing circle on the top edge of the top hat piece. Use blanket stitch to sew the hat together. The curl-shaped piece around to follow the song circle. You can see both ends of the shaped piece overlap at the end. Cut the ends so they respond well and sew them together.
The top hat should now be stitched brim. The upper part is the hole in the brim. The blanket stitch show inside here.
The two internal drives should be sandwiched between the top cap and base of the hat. The internal disks are slightly smaller and need to be placed outside the center so that the edge touches the back of the needle case, it will be the hinge zone.
Attach the threat on the left side of the area had articulated and 3cm blanket stitch on all four layers.
Following the hinge zone, keeping the wire attached to hat. Edge with the brim Stitch.
Re-attach the wire to the base of the hat on the left side of the hinge zone and the edge of the base with blanket stitch.
Cut flower shapes in contrasting felt. Tack the flowers for the hat with a couple of points, to finish the hat.
